Boardcon Idea6410 Manual de usuario descargar pdf (Pagina 22)

www.armdesigner.com

4.4. SD Card

SD Card port J12 supports SD Memory protocol 2.0 and SDIO protocol 1.0. As SD

Memory it can support up to 8G SD card, as SDIO it can support WIFI, GPS Module.

Also the SD Card can be taken as startup device for easily mass production and software

update. About detail configuration please see the chapter 3.5.

Below picture shows the circuit drawing of SD Card.

4.5. Camera interfaces

The camera interface supports 8bit ITU-R BT 601/656 mode and resolution up to

4096x4096 dots. The camera interface is a kind of 10*2 pin header connector at J10. The

interface not only has camera signal led out from CPU controlled but also has been added

signal IIC and CAM_PD/GPP14(GPIO). In normally the camera device is set by IIC, but

we added CAM_PD/GPP14 to protect IIC clashed with other external devices, once

happened this case, the CAM_PD/GPP14(GPIO) can replace IIC.

Also added CAM_PD/GPP14 for camera device power management like power off, power

save management and so on.

Boardcon developed a camera module which can directly connect with the board, and its

IDEA6410 Hardware Reference Guide

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 40 41

Sin comentarios

Boardcon Idea6410 Manual de usuario Pagina 22